PRODUCTS

LIFTS

Overhead lifts
Floor Lifts
Lift Specifications

SLINGS

Standard Slings
Specialty Slings
Sling Specifications

TRACKS

Tracks
Track Components

HOVERTECH

HoverTech
Repositioning Aids

 
Products - Tracks - Track Components

Track

The Track is used in single track system applications or as the parallel support rails for a gantry ('H') system. Also used as the 90 degree or 45 degree curves.

90 Degree Curve Track

Curved tracks are used to change direction of tracks in a single track system. The 90 Degree Curve can be used with other straight or curved tracks.

Traversing XY Gantry Trolley Set (Gantry Wheels)

The Traversing XY Gantry Trolley Set is used to connect the traversing boom to the parallel support rails for a gantry ('H') system. Available in manual and power traversing models.

Multi-Port Turntable -16 port

The Multi-Port Turntable provides the end-user with ultimate flexibility in lift and transfer situations that demand a wide range of locations. The turntable provides 15 different ceiling track take-off points each at 22 degrees. The turntable is easily rotated with the use of a simple pull cord mechanism.

Auto Gate

The auto gate enables a transfer between a gantry and a single track. It does not require an electric actuator nor a pull cord. In moving the lift to the track and through the gate, an auto gate pin slides into a beveled holder which locks the tracks in place until the lift returns.

SuperTrack

The SuperTrack is used as a traversing boom. Can also be used as the parallel support rails for a gantry ('H') system. Typically used for longer spans.

45 Degree Curve Track

Curved tracks are used to change direction of tracks in a single track system. The 45 Degree Curve can be used with other straight or curved tracks.

End-Stop & End-Stop Safety Pin

The End-Stop prevents the lift and/or the Traversing XY Gantry Trolley Set from rolling off the end of the track. The End-Stop is located inside the track typically at the end of each track, but can be adjusted and located anywhere along the track. The End-Stop Safety Pin acts as a redundant stop.

Quick-Fit Turntable 4 port

The Quick-Fit Turntable provides the end-user with 3 different ceiling track take-off points each at 90 degrees. The turntable is easily rotated with the use of a simple pull cord mechanism.

TrackPlus

The TrackPlus is used as a traversing boom. Can also be used as the parallel support rails for a gantry ('H') system. Typically used for longer spans, 5 to 6 m between attachments.

Ceiling Brackets (3" & 6")

The 3" Ceiling Bracket is used to fasten the track to the building structure. Brackets are spaced for load distribution. They transfer forces to the building structure. The 6" Connector Bracket is used in the same capacity, but connects or splices two pieces of track together.

Charger End-Stop

The Charger End-Stop is essentially an End-Stop integrating a charger station to charge batteries in the ceiling lift.

Trolley Assembly

The trolley assembly is a traversing wheel block located in the track. The portable lift is attached to the trolley with a manual charging device.